一、產品特性：

1.高度模塊化設計：可以方便地配用各種型式的電動機或采用其它動力輸入。同種機型可配用多種功率的電動機。容易實現各機型間組合聯接。

2.傳動比：劃分細，范圍廣。組合機型可以形成很大的傳動比，即輸出極低的轉速。

3.安裝形式：安裝位置不受限制。

4.強度高、體積?。合潴w采用高強度鑄鐵。齒輪及齒輪軸采用氣體滲碳淬火精磨工藝，因而單位體積承載能力高。

5.使用壽命長：在正確選型（包括選用適當的使用系數）和正常使用維護的條件下，減速機（除易損件外）的主要零部件壽命一般不低于20000小時。易損件包括潤滑油、油封以及軸承。

6.噪聲低：減速機主要零部件都經過精密加工，并通過組裝和測試，因而減速機噪聲較低。

7.效率高：單機型效率不低于95％。

8.可承受較大的徑向載荷。

9.可承受不大于徑向力15％的軸向載荷。

　　 特別細小的GF系列的斜齒輪電機配有軸裝用的平行軸，非常適合窨受限制的情況下使用。備有底腳安裝、法蘭安裝和軸裝型式。

 

一、Characteristics of product

1.High modularization design: may equip with various motor or other power input conveniently. Same machine type may equip with various power motor. It is easy to realize the combination and junction between every machine type.?

2.Transmission ratio: fine division, wide scope. The combined machine type may form very large transmission ratio, i.e. output very low rotary speed.

3.Form of installation: the position to be installed is not limited.

4.High strength, compact: the box body is made of high strength cast iron. Gear and gear shaft adapts the gas carbonization, quenching and fine grinding process, therefore the bearing capacity of unit volume is high.

5.Long life: Under the condition of correct type chosen (including choosing suitable operation parameters) normal operation and maintenance, the life of main parts of speed reducer (except wearing parts) should not be less than 20000 hours. The wearing parts include lubricating oil, oil seal and bearing.

6.Low noise: because main parts of speed reducer are processed, assembled and tested critically, therefore the noise of speed reducer is low.

7.High efficiency: the efficiency of single machine is not less than 95%.

8.May bear larger radial load.

9.It may bear the axial load that is not more than 15% of radial force. 

Particular fine GF series bevel wheel motor is equipped with parallel axis for installing axis. It is suitable to use under the condition of not limit. There are the forms of foot margin installation, flange installation and axis installation.